Metabo HPT SV 12SG Instrucciones De Seguridad Y Manual De Instrucciones página 13

2. Installing the sanding paper
[4-1/2" × 5-1/2" (114 × 140 mm) sanding paper (Clip type)]
(1) Bending the sanding paper:
○ Position the sander with its pad side facing upward as shown in Fig. 8. Place the sanding
paper on the pad so that the center of the sanding paper is aligned with the center of the pad,
and bend both ends of the sanding paper at a 90° angle.
○ Then, bend both ends again in the manner shown in Fig. 9. The sanding paper is now ready
to be installed on the sander.
(2) Installing the sanding paper
While ensuring that the cord is not bent,
place the sander on a workbench as
shown in Fig. 10, and insert one end of the
sanding paper (bent section). Next, insert
the remaining bent section in the same
manner.
CAUTION:
The sanding paper must be precisely
installed on the pad, ensuring that
there is ample tension (leaving no
slack). Loosely
paper could result in unevenly sanded
surfaces and/or damage to the sanding
paper itself.
Fig. 8
installed sanding
English
Fig. 9
Fig. 10
13