FLORABEST FGH 710 A1 Traduccion Del Manual De Instrucciones Originale página 45

Warning! The tines will con-
tinue to turn for a few sec-
onds after the tool has been
switched off. Do not touch
the rotating tines – injury
hazard!
Operating instructions
Always keep a firm grip on
the tool with booth hands
and watch your feet.
The tines may cause an ac-
cident.
Be careful while moving
backwards – danger of trip-
ping!
Do.not.touch.the.gearbox,.as.
it.may.become.hot.during.op-
eration.–.danger.of.burns!
To.avoid.damage.to.the.
tool:
.
• Never lift or drag the tool with the
motor running.
• Lift the tool while moving it over
hard surfaces such as tiles or
steps.
Switch the tool off after working with
it and for transport; disconnect from
the mains and wait for the tines to
stop moving.
• Walk the tool through the soil
at normal pace and in a line as
straight as possible.
• Always work away from the
mains socket. Make sure that the
cable is kept well away from the
working area. Hanging the cable
into the belt clip included in the
package will help.
• Overload.protection:.The
motor will cut out immediately
if overloaded. The tool cannot
be used until it has completely
cooled down again.
Cleaning,
maintenance, storage
Warning! Always return the tool
to the service centre for work not
described in the manual. Only use
original parts.
Switch the tool off, unplug it from
the mains, and wait for the tines to
stop moving before carrying out any
maintenance or cleaning work on
the tool.
Perform regular maintenance and cleaning
on the tool. This will ensure long, reliable
service.
General cleaning and
maintenance work
Do not spray the tool down with wa-
ter (especially not under pressure),
and do not clean it under running
water.
Wear protective gloves when carry-
ing out maintenance and cleaning
work on the tool to avoid injury from
cuts.
Always.clean.the.tool.thoroughly.
after.each.use..Always.keep.the.
tool.clean..Do.not.use.cleaning.flu-
ids.or.solvents.
• Remove any soil and dirt residues stuck
to the tines, driveshaft, tool surface
and vents with a brush or dry cloth.
• Spray or rub biodegradable oil into
the tines.
• Clean soiled grips with a damp cloth.
• Always check the tool for obvious dam-
age such as loose, worn or damaged
GB MT
45