Phonic ClubX 8 Manual Del Usuario página 6

Suspension
ClubX 2-way models feature twelve M8 flypoints for the installation of M8 bolts. These bolts can then be used for suspending the speaker
from walls and ceilings. Phonic advises that only experienced and qualified personnel perform suspension of speakers to ensure complete
safety. It's important to remember that if speakers are not securely suspended they may come loose and fall, potentially causing injury.
Below you can find three possible suspension types.
Connections
The ClubX passive loudspeakers all feature speakon connectors
for speaker input and link/thru outputs. Input is received on pin 1 of
the ClubX's input jacks, while the signal is sent directly through to
the "thru" outputs. On the ClubX 2-Way models, the "In" and "Thru"
jacks are interchangeable. This means that either connector can
be used as an input, and the other is then used as the "Thru" jack.
These "Thru" outputs allow the speakers to share the power from
a single amplifier. In this event, the total speaker amperage should
be halved. For example, two 8 ohm ClubX speakers will lower the
amperage to 4 ohms. This means the amplifier that powers the
speaker should be able to offer 4 ohm operation.
2
High Pass / Thru (ClubX 18SB)
The ClubX 18SB features an independent "thru" port that allows
the input signal to pass through in its entirety to additional passive
speakers to share the power of the connected amplifier. Users can
also apply a high pass filter to the outgoing signal by switching the
"High Pass / Thru" switch to the high pass position. The subwoofer
itself has an internal low-pass filter permanently activated. This
ensures that only low-frequency signals are passed through to
the subwoofer, creating deeper and more lush bass while also
protecting the subwoofer itself.
ClubX 8 / ClubX 10 / ClubX 12 / ClubX 15 / ClubX 215 / ClubX 18SB
RMS: 750W PROGRAM: 1500W PEAK: 3000W