Publicidad
Idiomas disponibles
Idiomas disponibles
6) Use the wrench to loosen and remove the blade bolt.
Turn the blade bolt clockwise to loosen. DO NOT remove
the inner blade washer.
7) Wipe a drop of oil onto the inner blade washer and the
outer blade washer where they come in contact with the
blade.
WARNING: If the inner blade washer
has been removed, replace it BEFORE
placing blade on the spindle. Failure to do so
could cause an accident because the blade
will not tighten properly.
CAUTION: ALWAYS install the blade
with the blade teeth and the arrow
printed on the side of the blade pointing
down at the front of the saw. The direction of
blade rotation is also stamped with an arrow
on the lower blade guard.
WARNING: To prevent damage to the
spindle lock, always allow the motor to
come to a complete stop before engaging the
spindle lock. Always make sure the spindle
lock is disengaged before reconnecting saw
to the power source.
8) Fit the new blade onto the spindle taking care that the
inner flange sits behind the saw blade.
9) Reposition the outer flange.
10) Depress the spindle lock button and reposition the blade
bolt.
11) Use the supplied wrench to tighten the blade bolt
securely (tighten in an anti-clockwise direction).
12) Re-tighten the locking screw (h).
13) Check that the blade guard operates correctly and
covers the blade as the operating handle is lowered.
14) Connect the saw to the power supply and run the blade
to make certain that it is operating correctly.
26
3. REPLACING THE CARBON BRUSHES (SEE
FIG. Q)
Check the carbon brushes regularly. If the carbon brushes
are worn down to about 4mm, replace them with the new
set (not supplied). It must be replaced in pairs.
With a suitable slotted screwdriver turn the cap counter-
clockwise until the carbon brush is released, replace the
brush and make sure that they locate well and are secured
within the brush retainer.
4. MOVING THE SAW
1) When transporting the saw, make sure that the saw
head is locked in the lower position.
2) The rotary table locking knob, the bevel lock lever must
all be securely tightened.
EN
Publicidad
