Publicidad
Idiomas disponibles
Idiomas disponibles
EN
3. CHAPTER 3 ROUTINE MAINTENANCE AND DISASSEMBLY AND
REPLACEMENT OF WEARING PARTS
3.1 Periodic inspection
Regular maintenance and inspection
1
2
3
4
5
6
7
8
3.2 Replacement and installation of the main brush.
●Make sure the machine is stationary
●Open the right side panel of the machine, use an open-end wrench to remove the rocker arm of
the main brush, the sealing plate and the fixing nut of the fender bracket;
-Take out the worn main brush, replace the new main brush, install the sealing plate nut first , then
install the fender support nut, and finally install the rocker arm nut;
Battery level detection
Motor carbon brush inspection
Whether the main brush is wired, the silk is
entangled
Is there any debris in the tank
Check the buttons on the control pa
The degree of wear of the brush
Whether the filter has impurities
Check the sprinkler joint for leaks
Intervals (h)
4
50
100
200
nel
9
500
Publicidad
