Cleaning Main Brush And Sidebrushes - Vileda VR 302 Manual Del Usuario

4.2 Cleaning main brush and sidebrushes

CLEANING OF SIDEBRUSHES
Check the sidebrushes after every use and remove dust and dirt stuck to the sidebrushes. Maximum life span for
sidebrush is 6 -12 months.
NOTE: Before replacing sidebrushes, please pay attention to the left mark and the right mark on sidebrushes,
which match with the 'L'/ 'R' mark on the bottom base of robot.
CLEANING OF MAIN BRUSH
Release the clamp on the right side
of the main brush kit and take it out
of the robot
Open the main brush cover
1. Let the lid of the main brush face
yourselves.
2. Both hands thumb holding the lid
of the main brush, push the red
part up.
3. Remove the cover of main brush.
Remove the main brush
1. Lever the red main brush retainer.
2. Remove the main brush from the
holder.
3. Clean the brush and the brush
holder, by either using the
maintenance brush or running
water.
NOTE: If hair is knotted on the main
brush, you can use small scissors to
cut and remove easily.
4. Re-install the main brush in the
original order of disassembly
after it is fully dry.
5. Check if sidebrush can rotate
free. Take care that the
sidebrushes are not trapped by
the main brush kit.
G
15