CASO DESIGN Slow Juicer Manual De Instrucciones página 41

Place the feeding tube (2) so that the symbol
the symbol on the strainer container (7). Press it down and rotate clockwise, so that the
symbol on the feeding tube (2) is above the symbol
Place the pusher (1) into the lid with feeding tube (2). Place
the residue container (10) under the outlet for residues (7a)
and the juice container (11) under the outlet for juice (7b).
To disassemble, proceed in the reverse order. However, you
can lift up the strainer compartment with the juice strainer or
sorbet insert, strainer frame and feed auger together and
only then disassemble them.
► The juice could leak out if the juice outlet cap is not
properly closed.
► Device will not operate if parts are not assembled properly.
► The feed auger must be engaged so that the feed tube
with the lid can be closed.
14.4 Switch
ON: Starts the feed auger
OFF: Stops the operation
REV: Pushes the food back up
14.5 REV-function
If the feed auger is blocked, use the REV function. The REV function removes blocked
food by moving it back up.
15 Operation and Handling
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
Please note
on the feeding tube will be place above
on the strainer container (7).
41