Husqvarna TC 112 Manual De Usuario página 13

Assembly overview
To install the steering wheel
Refer to Assembly overview on page 13 for the correct
fasteners for this task.
1. Install the steering column cover. The steering
column cover is attached by snap locks. Press down
on the steering column cover until it locks in position.
1903 - 002 - 06.02.2023
2. Put the steering wheel (A) on the steering column.
The pins on the steering column must go into the
slots in the steering wheel.
3. Install the washer (B) and the bolt (C). Tighten the
bolt to 24 Nm.
4. Install the center cover (D) on the steering wheel.
The center cover is attached with snap locks.
To install the knob on the throttle
control
Assembly overview on page 13 for the correct
Refer to
fasteners for this task.
D
C
B
A
13