Publicidad
Maintenance
How to Clean the Air Inlet Product Cover
1. Precautions before cleaning the Product Cover
- Too much dust on the Product Cover can reduce the wind volume and increase noise.
- Clean the Product Cover about once to twice a month.
- Do not disassemble the product except when cleaning the Product Cover.
- If the Product Cover is torn or damaged, replace it with a new one.
- Do not disassemble, repair or modify the product except from our service center.
2. Detach the Product Cover case
- Lower the hook on the Product Cover case with your finger and pull it out toward your body.
- You may need some force when you detach it for the first time.
3. Disconnect inlet Product Cover
The inlet Product Cover is consisted of a filter case and a filter.
4. Clean the inlet Product Cover
- It is recommended to clean the Product Cover outdoors because it can cause a lot of dust.
- As the Product Cover is made of sponge material, please remove the dust first and then wash
it with water.
- Please use the Product Cover when it is completely dry.
When cleaning with water, please do not use any detergent.
5. Above cleaning method
- Please wipe the remaining water with a dry towel.
22
Publicidad
