Publicidad
Idiomas disponibles
Idiomas disponibles
each.
Fig. 21/34:
•
(a) Push the spring and the lower hinge part [13] into the
already screwed upper hinge part.
•
(b) Screw the inner spring in the upper hinge part in the
third hole from the top and the one in the lower hinge
part in the first hole from the top with 2x screws [20].
Fig. 22/35:
CAUTION! Two people needed.
•
Turn the frame 180° so that the outside of the door is on
top. Place the door against the door frame and underlay
it with a shim at the desired height so that the door over-
laps the frame by 15 mm in each place.
•
(a) Drill the screw channels in the door frame through
the bottom two holes of each hinge.
•
(b) Screw the door tight through the hinges in the pre-
drilled holes with the enclosed bit [15] and 2x screws
[21] each.
Fig. 23/36:
•
(a) Place the counter plate [14] on the inside of each
magnetic catch.
•
(b) Close the door.
•
(c) Screw the counter plates [14] with the enclosed bit
[15] and 2x screws [16] each to the door frame.
• Cleaning
Use only a damp cloth with mild detergent for cleaning. You
can remove dust from the fibreglass fabric with a vacuum
cleaner (brush attachment) or hand broom.
• Storage
Store the product dry and clean in a temperature-controlled
room when not in use.
• Disposal instruction
Don't forget about environmental protection. There is a pub-
lic take-back system for the disposal of packaging materials
and old appliances. You can get information about collec-
tion points and current regulations from your city or munici-
pal administration.
• Liability
In the case of non-observance of the instructions and infor-
mation given in this manual, in the case of improper use or
use outside the intended purpose, the manufacturer rejects
the warranty for damage to the product. Liability for con-
sequential damage to elements of any kind or persons is
excluded.
• Warranty
The product has been carefully produced according to strict
quality guidelines and conscientiously tested before delivery.
In the event of defects in this product, you have legal rights
against the seller of the product. These statutory rights are
not limited by our warranty set out below.
This product comes with a 3 year warranty from the date of
purchase. The warranty period begins on the date of pur-
chase. Please keep the original receipt in a safe place. This
54 | GB
document is required as proof of purchase.
If a material or manufacturing defect occurs within three years
from the date of purchase of this product, we will replace the
product, free of charge for you, with a product of our choice.
This warranty is void if the product is damaged, improperly
used or maintained.
The warranty covers material or manufacturing defects. This
warranty does not cover product parts that are subject to nor-
mal wear and tear (e.g. weathering) and can therefore be con-
sidered wear parts or for damage to the fabric that has been
torn by heavy use (stretching or sharp objects).
• Manufacturer/Service
bash-tec GmbH
Hoorwaldstr. 42
DE-57299 Burbach
GERMANY
service@bash-tec.com
IAN 383066_2110
For all inquiries, please have the receipt and item number (e.g.
IAN 12345) available as proof of purchase.
Note: The pictures in this manual are exemplary and may dif-
fer from the product.
Assembly
Publicidad
