Publicidad
Idiomas disponibles
Idiomas disponibles
The information you will find in this manual has been written to assist the operator in the use
and maintenance of the compressor. Some illustrations in this manual show details which
may differ from those of your compressor
After having taken the compressor out of its packaging and having checked that it is in
perfect condition, and having noted that no damage occurred during transport, the following
acts should be performed. If not yet fitted, fit the rubber feet and the wheels on the tank
according to the instructions represented in. Place the compressor on a flat surface or at a
maximum slope of 10°, in a well ventilated area, protected against atmospheric factors and
not in explosive surroundings. If the surface area is sloping and smooth, make sure that the
compressor will not move when in operation. If the surface area is a board or a shelf of a
bookcase,just make sure that they cannot fall down by securing them properly. For proper
ventilation and effective cooling, it is important that the compressor is positioned at least 100
cm from the wall.
Recommend to use the wheel chock to prevent movement during parking and use.
The machine cannot be carried and moved by the traction device. Can only be pulled by the
handle of the machine.
If need to lift the machine, two peoples are advised.
Make sure that the compressor is transported in the right way, do not
turn it upside down and don't lift it with hooks or ropes.
Filling the compressor with oil.
Before use, remove the transport oil lid on the carter, and fill the oil into the compressor, then
screw the supplied oil filler breather plug (12) instead back . Before use, ensure that oil level
is sufficient. This can be checked by checking the oil inspection glass (13). When compressor is
placed horizontally, the oil level shall reach the red mark.
Installing the air filters.
Screw the supplied air filters before using the compressor.
5. BEFORE FIRST USING
9
EN
Publicidad
