Publicidad
Idiomas disponibles
Idiomas disponibles
6. ASSEMBLY
FR
ES
PT
MOUNTING THE CUTTING DISC
IT
• Raise the 45° vertical fence approx. 45° and remove.
• Loosen cross-screws with the star-head screwdriver (not supplied) and pull off lower protective guard.
• Attach the straight wrench to the hex nut .
EL
• Use angle wrench to lock the motor shaft.
• Loosen hex nut counter-clockwise using straight wrench.
PL
direction.
UA
• Screw hex nut onto motor shaft clockwise.
• Attach the straight wrench to the hex nut.
RO
• Use angle wrench to lock the motor shaft.
• Tighten hex nut clockwise using straight wrench.
• Re-attach the lower protective guard and tighten cross-screws.
EN
• Replace the 45° vertical fence.
Important: Always select a cutting disc which is suited to the workpiece to be cut. Deformed, cracked
or dull cutting discs must not be used. Wear protective gloves. Cutting disc accessories which are used
on this machine must be compatible with the cutting disc in the scope of delivery with respect to their
technical and qualitative characteristics. Compare the technical information with the data in this user
manual. Take particular not of the nominal rotational speed and the dimensions. Only use cutting discs
whose highest permissible speed (rpm) is not lower than the maximum shaft speed (rpm) of the tile
cutter and the material to be cut. Also follow the recommendations of the accessory manufacturer.
When mounting the cutting disc, ensure that the cutting width is not less and the thickness of the
cutting disc is not greater than the thickness of the mental bracket.
WARNING ! Pull out the power plug before assembling, adjusting
and changing the cutting disc.
WARNING !
placing cutting disc on motor shaft. Failure to do so could cause
an accident, since the cutting disc will not tighten properly. Never
use cutting discs that have openings, grooves or teeth on this
tool.
Check the cutting disc for visible damage before installing it.
Worn, bent or partially cracked cutting discs must not be installed
under any circumstances.
Always be carefully when installing the cutting disc that the
direction of rotation of the cutting disc is the same as that of the
machine. The arrows on the cutting disc must always point in the
same direction as the arrow on the upper protective guard.
cutting disc going in the counterclockwise
135
Publicidad
