Dexter 450ETC1-18030.1 Manual De Instrucciones página 136

Idiomas disponibles

WARNING ! Do not lose the special wrenches for mounting the

cutting disc. They are indispensable for safe mounting of the disc.

Make sure once again that the cutting disc is attached securely

and perfectly. Check the correct rotational direction again. Turn

the disc manually and check that it runs and rotates freely. Make

sure that the hex nut is fully tightened.

ASSEMBLE/ADJUST THE METAL BRACKET

• Raise the 45° vertical fence approx. 45° and remove.

• Loosen the cross-screws with the star-head screwdriver (not supplied) and remove them.

• Push metal bracket into the place located under the working table and align the holes on the metal

bracket with the working table.

• Tighten cross-screws.

• Replace the 45° vertical fence.

WARNING! The metal bracket must always be aligned to the

cutting disc so that the metal bracket does not Interfere with

material being cut.

MOUNTING THE UPPER PROTECTIVE GUARD

• Align upper protective guard with metal bracket and slide over metal bracket. Line up through holes

in upper protective guard with slot in metal bracket.

• Install hex bolt through upper protective guard and metal b

before the thread locking knob and tighten the locking knob.

• Ensure that upper protective guard can move freely and that it cannot touch the cutting disc when in

use.

WARNING! Product damage! Do not over-tighten hex bolt and

locking knob. The upper protective guard must be free to rise and

fall as the workpiece is pushed toward the cutting disc.

MOUNTING THE PARALLEL CUTTING GUIDE

• Slide the parallel cutting guide from the side of the working table.

• Turn locking knob clockwise to tighten securely.

ADJUSTING THE PARALLEL CUTTING GUIDE

• Gently turn locking knob on parallel cutting guide counter-clockwise to loosen.

• Use parallel cutting guide scale, located on front and rear of working table, to set parallel cutting

guide to desired width of cut.

• Turn locking knob clockwise to tighten securely.

INSTALLING THE MITRE CUTTING GUIDE

• Push mitre cutting guide down onto parallel cutting guide.

• Adjust parallel cutting guide to desired position and secure.

• Adjust to desired angle using angle scale and tighten securely with locking knob .

WARNING! The mitre cutting guide can be set to a desired angle

(0°-45°). The mitre cutting guide can only be used when the

parallel cutting guide is mounted.

136