Publicidad
Idiomas disponibles
Idiomas disponibles
EN
16.- DIP selectors:
a.- LINE/MIC: modifi es microphone input (MIC) sensitivity or for players/mixers
(LINE).
b.- PHANTOM 48 V: enables/disables the PHANTOM 48 V power at the connectors
of this input, required for condenser microphones.
c.- CHIME: enables/disables CHIME tone generation function when a contact
closure is performed on the corresponding CHIME entry.
d.- VOX 1-3: enables/disables the priority of this input.
17.- Euroblock connector:
a.- +, -,
: input terminals for balanced input signal connection. CH 1
another combo connector to connect the input signal, CH 2, CH 3, CH 4
and CH 5 only have this euroblock connector for the input signal connection. In
addition, this input has DIP switches (16) to adjust the sensitivity of the MIC/LINE
input, enable phantom power, and enable/disable VOX and CHIME priority.
b.- CHIME: closing contacts to trigger a CHIME tone.
18.- CHIME: CHIME tone inputs CH 1-5 volume control.
19.- EMERGENCY IN: 100 V line level audio emergency system input connection, euroblock. If it is a line
signal use LINE and COM, if it is 100 V use 100 V and COM.
OPERATION
INPUT PRIORITY
-
The VOX priority of the various inputs is activated by signal level and can be regulated with the VOX
controls on the rear panel.
-
The priority of CH 1-5 can be disabled by using the DIP VOX 2 (CH 1) or VOX 3 (CH 2-5) DIP swich.
-
Priority order:
The REMOTE MUTE input attenuates all inputs except the EMERGENCY IN input when a contact closure
is performed in one of its terminals.
1.- EMERGENCY IN input has the highest priority attenuating all other inputs when it has a signal.
2.- CH 1|PAGING MIC input has priority over inputs CH 2, CH 3, CH 4, CH 5, AUX 1-3 and the player.
3.- The CH 2, CH 3, CH 4 and CH 5 inputs have priority over the AUX inputs and the player.
4.- The AUX inputs and the player have no priority over any other signal.
FM/USB PLAYER
To operate the player you must activate this input by pressing the PLAYER button and the LED on this
button will light up. Select the mode with the MODE button:
- FM RADIO MODE
-
Select FM mode.
NOTE: To use this mode, you need to connect an antenna to FM ANTENNA on the rear panel.
-
Perform an automatic tuning of the stations to start using this mode by long pressing the button
-
Once fi nished, you can select the station you wish to listen to from among those already set with
- USB MODE
-
Select USB mode.
-
Connect the USB device.
-
Press
and
to change the song or
-
You can change the play mode between repeat all (1 tone) and shuffl e (2 tones) by long pressing the
button
.
to pause/resume playback.
- 4 -
1
2
3
19
18
a bc d
19
18
17
a
has
a bc d
17
a
R
L
16
b
.
and .
Publicidad
