Hella Gutmann CSC-Kit Radar III Manual De Instrucciones página 35

Hella Gutmann
CAUTION!
Laser radiation
Damage to/destruction of the retina
Never look directly into the laser beam.
6. Switch on the laser module.
The laser point is indicated on the even ground surface.
7. Perform steps 5 and 6 for the second laser module.
Now both wheel alignment modules are correctly attached to the front wheels.
5.2.2. Positioning the Base Support at the Right Distance in Front of the
Vehicle
Proceed as follows to place the base support of the Rear Cam Kit I Basic at the right distance and parallel in front of the
vehicle:
1. Connect the diagnostic device to the vehicle (see mega macs user manual).
2. Select >Diagnostics< in the main menu.
3. Select the system to be calibrated under >Basic settings<.
4. Position the base support in front of the vehicle.
5. Read the correct distance in the diagnostic device.
NOTICE
Regard the different reference marks depending on the individual manufacturer.
6. Measure the distance between from the base support (front) to the reference point determined by the manufacturer
and position the base support accordingly.
Now the base support is positioned at the right distance in front of the vehicle.
5.2.3. Placing the Base Support Centred and Parallel in Front of the
Vehicle
Proceed as follows to place the base support of the Rear Cam Kit I Basic centred in front of the vehicle:
1. Switch on the laser module of the wheel clamp module.
2. Turn the laser module so that it points towards the measuring scale of the base support.
The laser beam is reflected on the measuring scale of the base support.
3. Perform steps 1 and 2 for the second laser module.
CSC-Kit Radar III
Working with the Radar Kit III | 5.
35