Hella Gutmann CSC-Kit Radar III Manual De Instrucciones página 36

5. | Working with the Radar Kit III
4. Position the base support by moving it axially until the same value is indicated on the left and right of the measuring
scale. Pay attention that the left and right distance to the base support is identical (parallelity).
5. Switch off the laser module of the wheel clamp module.
Now the base support is placed centred and parallel in front of the vehicle.
5.2.4. Positioning the Radar Reflector
Proceed as follows to position the radar reflector in front of the vehicle:
NOTICE
The radar reflector to be used is manufacturer-specific and has to be used in combination with the diagnos-
tic device.
1. Read the correct value in the diagnostic device.
2. Position the radar reflector CSC 4-04 or/ CSC 4-05 / CSC 4-07 at the base support by using the grooves in the base.
The respective value X for that is indicated in the diagnostic device.
NOTICE
Pay attention that the grooves in the base and in the turntable align.
3. Switch on the laser.
4. Adjust the radar reflector CSC 4-04 / CSC 4-05 / CSC 4-07 to the height indicated in the diagnostic device.
NOTICE
Regard the manufacturer-specific reference marks.
NOTICE
The calibration can be influenced by metal objects. Remove the base support before you can start the cali-
bration.
36
Hella Gutmann
CSC-Kit Radar III