Hella Gutmann CSC-Kit Radar III Manual De Instrucciones página 38

5. | Working with the Radar Kit III
4. Position the base support behind the vehicle.
5. Read the correct distance in the diagnostic device.
NOTICE
Regard the different reference marks depending on the individual manufacturer.
6. Measure the distance between the base support (front) and the center of the wheel hub (laser point on the ground
floor) with a tape and position the base support accordingly.
7. Perform step 6 for the second wheel alignment module.
Now the base support is positioned at the right distance and parallel behind the vehicle.
5.3.3. Positioning the Base Support Centred Behind the Vehicle
Proceed as follows to position the base support of the Rear Cam Kit I Basic centred behind the vehicle:
1. Switch on the laser module of the wheel clamp module.
2. Turn the laser module so that it points towards the measuring scale of the base support.
The laser beam is reflected on the measuring scale of the base support.
3. Perform steps 1 and 2 with the second laser module.
4. Position the base support by moving it axially until the same value is indicated on the measuring scale on the left and
right.
5. Switch off the laser module of the wheel clamp module.
Now the base support is placed centred behind the vehicle.
5.3.4. Mounting the Positioning Aid
Proceed as follows to mount the positioning aid:
NOTICE
With the help of the Rear Cam Kit I Basic the positioning aid enables the exact positioning of the radar reflec-
tor CSC 4-04 / CSC 4-05 / CSC 4-07 in the course of the manufacturer-specific adjustment of rear radar sen-
sors.
38
Hella Gutmann
CSC-Kit Radar III