Publicidad
23. Place the microfiber pad on the floor white side facing up. Place
steamer onto pad making sure the entire pad covers the floorhead.
24. With microfiber pad attached, push steamer into front of the carpet
glider, then place back of the floorhead into the clip. The carpet
glider should only be used when refreshing carpets.
25. Plug into mains and twist On/Off control dial to on.
26. Turn the detergent dial to OFF when refreshing carpets.
27. Place your foot on floorhead and pull handle backwards to recline.
28. To produce steam squeeze the trigger in short bursts. Don't hold
the trigger continuously to prevent over wetting carpet.
29. Move the steamer slowly backwards and forwards across the
carpet paying particular attention to high traffic areas. Squeeze/
release trigger as required.
30. To release the carpet glider, place your foot on the clip and push
down. Lift steamer to remove.
USING THE HANDHELD STEAMER
CAUTION: Always switch off the steamer before attaching the
concentration tool and accessories.
IMPORTANT: The handheld is to be used with water only, putting
detergent into the water tank can cause damage. Always check
the tools are clean and free from debris, don't use if damaged,
broken or worn.
31. Lift the handheld release button and gently pull the handheld to
release from the steamer.
Publicidad
