Publicidad
Idiomas disponibles
Idiomas disponibles
Unplug your product. The ice generally melts in two hours.
Remove the cover from the drain hole, located on the lower front
Place a container on the bottom, for preventing the melted ice waters to damage the
floor. Place the drain hole cover.
After defrosting operation, wipe internal walls with a dry cloth to make sure that they
are not wet.
Run your device empty again for three hours and wait for it to cool down. Then you can
place your foodstuff in it.
TURN OFF
Transfer the foodstuff inside your product to a convenient place.
Unplug your product. (Picture 15)
If your product will not be used for a long time, apply following considerations:
Clean your product. Otherwise, the humidity on the wall may cause darkening of the
−
internal surface.
CAUTION!
If your product will be stored at an indoor place (mandatory), after shutdown:
Do not cover it with plastic sheets. Plastic will cause smell and sweating of your product
as it does not breathe. Corrosion may be seen as the result of sweating.
Smell formation may occur in cases where you fail to store your product with the door
open.
PICTURE 15
53
Publicidad
