Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING, MAINTENANCE AND TRANSPORT
Cleaning of your device is composed of two stages, which are the internal cleaning and
external cleaning.
Following warnings must certainly be abided before start cleaning.
CAUTION!
Unplug your product before every cleaning.
Always wear protective gloves during cleaning and maintenance. This will protect you
from injuries.
Never use domestic cleaning agents, abrasive and scratching substances (surface
cleaners, detergent, flammable and sparkling, solvent like gasoline, thinner, acid) as
cleaning agents. Otherwise loosening may occur in the plastic parts of your product.
Never use flowing and pressurized water for cleaning.
INTERNAL CLEANING
Transfer the foodstuff inside your product to a convenient place.
Before the internal cleaning, wait until the temperatures of the internal parts of your
product reaches to the ambient temperature.
Always wear protective gloves during cleaning and maintenance. This will protect you
from injuries.
Remove the accessories from inside.
Perform cleaning with a soft cotton cloth and warm soapy water or by using the cleaning
agents recommended.
Dry with a dry cotton cloth. Products, which are not dried, may darken in time.
Make sure that no wet or humid area is left in the internal section after cleaning.
You can reload your product three hours after running your product as stated in this
manual.
EXTERNAL CLEANING
Clean with a cotton cloth and warm soapy water.
Prevent penetration of cleaning water into the front control panel and lighting section
while cleaning.
Clean the door gasket by using clean soapy water only.
MAINTENANCE
Clean the dust accumulated on the condenser, which is on the back part of your device
with the help of a vacuum cleaner or a dry brush after unplugging the device. Repeat
this process a few times in a year.
54
Publicidad
