Publicidad
Idiomas disponibles
Idiomas disponibles
Technical assistance
Your vacuum/blower should only be serviced by the
manufacturer's internal service personnel, or other
qualified personnel, replacing any necessary parts with
original parts sourced directly from the manufacturer.
ASSEMBLY INSTRUCTIONS
Tube
1. Fit the tube (1) into the air outlet (2);
2. Turn the tube clockwise to secure.
Tube assembly on the air inlet and dust bag
Never attach or replace the tube when the
vacuum/blower is running.
1. Place the tube (1) into the air inlet (5);
2. Turn the tube clockwise to secure.
3. Fit the dust bag into the air outlet (2);
4. Turn the dust bag clockwise to secure.
Always empty the dust bag after you have
finished your job. Open the bag's zipper to
remove any dust.
OPERATING INSTRUCTIONS
When working with the vacuum/blower, you should
consider some procedures:
▪ Never vacuum/blow hard objects such as stones,
bottles, cans or pieces of metal. This type of objects
can damage the fan and harm the user;
▪ To avoid motor damage due to overspeed, do not
block the end of the vacuum/blow tube;
▪ Never put the blower down before the engine has
completely stopped;
▪ Switch the blower off immediately if any of the
following problems occur:
- Lubricant leakage through ventilation holes;
- Damage to the vacuum/blower housing;
- Damage to the "ON/OFF" switch;
Appearance of smoke or characteristic burning smell;
Starting and stopping the vacuum/blower
1. To switch on the vacuum/blower, press the
"ON/OFF" switch (6);
2. To turn off the vacuum/blower, simply release the
ON/OFF switch;
ON/OFF switch lock-on knob
For continuous operation, press the ON/OFF switch and
lock-on knob (4). To release the lock-on knob, press the
ON/OFF switch;
MAINTENANCE AND CLEANING INSTRUCTIONS
Before inspecting, performing any maintenance or
cleaning work, unplug the power cord.
The vacuum/ blower does not require any additional
lubrication or maintenance. However, regular cleaning
should be carried out to ensure continuous, trouble-
free operation.
Checking and replacement of the carbon brushes
Remove and check carbon brushes regularly. They
should be replaced when they are 6mm or less. Keep
the brushes clean and free.
Always replace both carbon brushes at the same time.
1. Remove the carbon brushes cap;
2. Remove and replace them;
3. Put the cap back on.
Cleaning and storage
Cleaning
After each use, clean all vacuum/blower components.
Clean the power tool with a clean, moist cloth or blow
with low pressure compressed air.
Careful handling protects the power tool and extends its
service life.
The power tool and its ventilation slots must be kept
clean. Clean the ventilation slots regularly or whenever
they become blocked.
Storage
When not in use, store the vacuum/ blower in a dry,
clean place, free of corrosive smoke and out of the
reach of children.
25
Publicidad
