Publicidad
Idiomas disponibles
Idiomas disponibles
2
1
to SUB
MASTER
MASTER
2
-
Turn on the power (MASTER unit only). This is possible through 3 methods: 9 V battery (1), 9-12 V DC
power adapter (2) or 12 V DC direct current source (3).
NOTE: Connect the devices by means of the before mentioned methods only.
1.- Remove the rear cover of the main unit and insert a 9 V battery making sure that the polarity is
correct. Battery power is not recommended for extended use, in these cases power the intercom
1
via methods 2 or 3.
2.- Connect a power adapter to the 9-12 V DC plug with the polarity indicated next to the plug.
MASTER
3.- Remove the back cover and connect the power supply to the 12 V DC and GND terminals.
1
MASTER
1
MASTER
MASTER
9 V
Install both units: On a flat surface (1) or hanging from the wall using screws in the holes on the rear (2).
1
1
1
MASTER
SUB
SUB
MASTER
2
SUB
LINE +
LINE -
2
3
9 V
9-12 V DC
9 V
2
MASTER
MASTER
2
to MASTER
LINE +
LINE -
MASTER
LINE +
LINE -
1
MASTER
9-12 V DC
2
9-12 V DC
1
GND
12 V DC
12 V DC
2
6 mm
~3 mm
2
- 3 -
SUB
SUB
LINE +
LINE -
SUB
2
3
9-12 V DC
3
9 V
GND
2
~3 mm
EN
SUB
SUB
3
GND
12 V D
12 V DC
12 V DC
12 V DC
6 mm
GND
12 V DC
~3 mm
12 V DC
6 mm
6 mm
~3 mm
Publicidad
