Publicidad
Idiomas disponibles
Idiomas disponibles
Hoyer
®
Presence
3. Tighten the mast assembly with the mast-locking device, which is located at the front of the
chassis.
Avoid trapping fingers. Keep fingers away from the end of the mast when inserting into
the chassis socket. Full engagement of the mast is indicated by the label on the side of
the mast. The electric leg operation will not function unless the mast is fully engaged.
4. Turn the locking knob until hand tight.
5. Line the handle assembly up to the rear of the mast, and attach using the screws provided.
The screws and wrench needed to attached the handle are kept in the user instruction wallet
for safe keeping.
NOTE: When attaching the handle to the mast be sure that all trailing wires are left outside the
handle before fixing.
6. Fit power pack to the lift and make sure the latch holding the pack in place is fully engaged.
"Click" in place.
7. Plug the handset and actuator cables into the bottom of the controller. Refer to the figures on
page 11 or 12 for correct positions.
6
WARNING
English
Publicidad
