Thinkcar THINKSCAN Max Manual De Instrucciones página 21

THINKSCAN Max
www.mythinkcar.com
(Graph): Click it and the data streams are displayed in dynamic wave patterns.
Report: Click the button to save the number of current data streams.
Record: It's used to record diagnosis data so that users can replay and check it. If
you want to stop the reading, click "stop" (the white box before the progress bar). The
diagnostic record is saved in the ThinkFile module. It can be sent to designated e-mail
boxes and reviewed for troubleshooting and analysis.
If the 1 / X appears, it means that the data stream options haven't fully displayed. Swipe
the screen from bottom to top to display the remaining options. With 3 display modes
available, you can browse it with suitable ways:
• Figure: Displays parameters with wave patterns.
• Value: The default display mode shows parameters with numbers and lists.
Note: If the value of the data stream is not within the standard value range, the data stream will be
displayed in red.
• Combine: The graphs are presented together for users to make comparisons.
Note:diff erent data fl ow options are marked in diff erent colors.
How to check one wave pattern?
Click .
On the display page of wave patterns.
Choose the data stream options to be checked (Note: Only a maximum of 4 data streams can
be displayed).
If you want to remove the wave pattern of some data stream, just deselect it.
How to check several wave patterns together?
Click [Combine] button and then the system will display the parameters of the selected
data streams with wave patterns.
19