battioni Pagani GARDA EVO Serie Manual De Instrucciones De Uso Y Mantenimiento página 158

instruction manual
for use and maintenance of the combined groups for the GARDA EVO series
8.2 - WASHING THE GEARBOX
At least once a year, wash the gearbox.
• Remove the oil from the gearbox;
• Remove the cover from the gearbox;
• Wash the gearbox using suitable solvents;
• Top up the lubricating oil;
• Return the cover of the gearbox.
9 - MALFUNCTION, FAULT, FAILURE, PROBLEM, CAUSE AND
DETECTED FAULT
Irregular outflow of sewage from
the supply pipe of the centrifugal
pump
Irregular outflow of sewage from
the supply pipe of the centrifugal
pump
The mechanical seal whistles
The supply pressure
centrifugal pump does not reach
the operating values
The gearbox is cracked
The rotary blades vacuum pump
does not turn
9.1 - PUTTING OUT OF SERVICE AND DEMOLITION OF THE GARDA EVO
COMBINED GROUP
Before demolishing the combined group, the following materials must be separated:
• lubricating oil;
• rubber and plastic parts;
• cast iron and steel parts;
and disposed of correctly.
Do not dispose of the combined group into the environment.
For disposal of the lubricating oil make use of specialised treatment services.
page 140
SOLUTION
CAUSE
The sewage is too thick
Air infiltration
Irregular outflow of sewage from
the supply pipe of the centrifugal
pump
The supply piping is blocked
The gate valve lever located above
the centrifugal pump is closed.
The mechanical seal is burned due
to insufficient slurry.
The impeller blades are worn or
broken
Rate of revs is too low
of the
The PTO of the tractor does not
have enough power to reach the
maximum pressure
The diameter of the output hole of
the nozzle of the swivel jet is too
wide
A turn was made without removing
the cardan shaft.
Overly abrupt starting has broken
the key connecting the rotor shaft
with the pinion of the rotary blades
vacuum pump.
SOLUTION
Dilute the sewage
Eliminate infiltration
Position the handle
Eliminate blockages
Open the gate valve
Replace the mechanical seal
Replace the impeller
Increase rate of revs
Increase power
Decrease the diameter of the output
hole
Disconnect the cardan shaft before
performing any manoeuvre and
replace the gearbox.
Replace the key and where
necessary the rotor and the pinion.