Kinderkraft FOLDEE Manual De Instrucciones página 18

• Keep children away when unfolding and folding the
product to avoid injury.
• Product located under a window could be used as a step
by the child and cause the child to fall out of the window.
1. Parts:
1. Seat
2. Front and back legs
3. Double tray
4. Footrest
5. Fabric basket
2. Assembly and adjustment:
Legs
Remove the foam pads from the tube ends before assembly. To unfold the seat (1), pull the
backrest (fig. A). Pull the backrest towards you until you hear a characteristic 'click' (fig. B).
Mount the legs (2) to the seat (1). To do this, turn the seat upside down. Insert the legs (2) into
the tubes so that the pins are in the holes of the legs (1) (fig. C). A characteristic 'click' indicates
correct assembly. Repeat for the back legs (2). Stand the chair on its legs.
Tray
Attach the plastic tray (3) to the chair using the snap mechanism. Press the two buttons under
the tray, and slide the tray into the guides on both armrests (fig. D).
The tray (3) can be set in one of three positions - the marking is on the armrests (fig. E). When a
certain position is reached, you will hear a characteristic click.
In addition, check that the tray is correctly secured on both sides.
The top layer of the tray can be removed to wash it.
Footrest
Then mount the footrest (4). As with the leg assembly, insert the tube with the pin into the
designated hole (Fig. F). A characteristic 'click' indicates correct assembly. The footrest can be
set in two different positions by pushing in the pin and adjusting the appropriate level.
WARNING! Do not stand on the footrest.
Backrest adjustment:
The backrest of the chair can be set in three positions (fig. G). To adjust the angle of the backrest,
lift the lever at the back, tilt the backrest and put it in the desired position, then release the
lever. The backrest will lock automatically and a locking sound will be heard.
Safety harness:
WARNING: The use of a safety harness is essential to ensure the safety of the child. Using the
tray alone does not provide proper support for the child. Always use the safety harness.
The safety harnesses are adjustable and can be fitted in two positions depending on the height
of the child.
Fastening the safety harness:
Connect the shoulder, lap and crotch harness in the buckle. The correct fastening of the
harnesses is shown in figure H. Adjust the length of the harnesses to suit the child.
18