Publicidad
Idiomas disponibles
Idiomas disponibles
Cleaning and maintenance
Replacing the cartridge
1. Shut off the water supply to the faucet.
2. Turn on the faucet briefly to relieve any
pressure inside the faucet.
3. Move the faucet handle to the "OFF"
position.
4. Remove the set screw from the Handle
Assembly (A) using a 2.5 mm
Hex Key.
5. Pull the Lever Handle (A) from faucet
body.
6. Unscrew the Cartridge Cap (B) from
faucet body.
7. Unscrew the Cartridge Lock Nut (C).
8. Lift Ceramic Disc Cartridge (D) from
the body and repalce it with a new one.
Ensure the two lugs on bottom of the
cartridge sit properly in the allocated
holes at the base of the body.
9. Re-assemble faucet in reverse order.
10. Test for leakage.
General maintenance
Clean aerator periodically for any buildup.
Do not use harsh detergents, solvents,
chemical agents, especially CHLORINE,
or metallic sponges as these can damage
the surface finish. Clean only with a soft
sponge and soapy water.
Do not store chemicals or cleaning
agents in the immediate vicinity of the
faucet and connection hoses. Chemical
vapors could cause damage.
Attention! For outdoor installation
product must be protected from
freezing temperatures. Disconnect
hot and cold supply hoses from home,
open the handle to drain out all water.
Disconnect spray hose and ensure all
water is removed from spray hose/
spray head. Cover faucet with protective
covering to keep warm.
D
C
30 mm
106 in-lbs
7
B
A
EN
2.5 mm
Publicidad
