Descargar Imprimir esta página

NateoSante Hygeolis Manual De Instalación página 13

Publicidad

Idiomas disponibles

Idiomas disponibles

On/sleep mode
• To switch Hygeolis on or off, press the On/Off switch on the front at the bottom
When the unit is on, a blue LED
2
On/off switch
:
• To put the unit in sleep mode, press button A on the remote control for 3 seconds. To restart, press
button A again for 3 seconds.
Speed adjustment
There are three ventilation speeds. The slow speed enables continuous silent operation, while the high
speed enables rapid, high-output operation. The intermediary speed offers a compromise between noise
levels and treatment speed.
• Press the speed adjustment button at the top of the front panel
speed 1 ==> speed 2 ==> speed 3 ==> speed 1 ==>, etc.
• Press button A on the remote control. Press repeatedly to change speeds: speed 1 ==> speed 2 ==>
speed 3 ==> speed 1 ==>, etc.
Active oxygen
General
The air purification process uses active oxygen; it is based on the generation of ozone (O
quantities. Ozone is a very powerful natural detergent and, like bleach or chlorine, this feature must be
used with caution.
Two quite different active oxygen treatment modes have been developed to fulfil all requirements. They
are adapted to the volume of the room and can be adjusted by the user.
- MODE 1: acts mainly on odour elimination (cigarettes, body odour, drains, etc.). Ozone is generated in
small quantities and enables continuous treatment.
- MODE 2 (Clean Booster): purifies the air in the room intensively by destroying micro-organisms and
persistent odours. Ozone is generated in large quantities, which means the room must be free from
people and animals for 30 minutes.
Operation
- MODE 1 - continuous treatment
• Open the cover. To do so, unscrew the two screws
• Adjust treatment according to the surface area of the room using the adjustment button
Turn the button using a small, flat or cross-head screwdriver.
• The adjustment positions are as follows:
• OFF - MODE 1 off - no ozone emission
• 1 - low - surface area 5-15m² / slight odour
• 2 - moderate - surface area 10-25m² / notable odour
• 3 - high - surface area 20-45m² / strong odour
By default, the button is in position OFF. As the button is turned, a light and sound signal indicates the
selected position:
• OFF - no signal
• 1 - One beep and red LED on the front flashes once
• 2 - Two beeps and red LED on the front flashes twice
• 3 - Three beeps and red LED on the front flashes three times
The light signal is also activated whenever the unit is switched on, to inform the user of the position setting.
Active oxygen adjustment button
- MODE 2 - intensive Clean Booster treatment
• Press button B on the remote control for 3 seconds.
• The Clean Booster treatment cycle begins. There is a 30-second delay to allow the user to leave the
13 - Hygeolis
3
is lit on the front panel.
1
:
6
. Press repeatedly to change speeds:
5
using the torx wrench provided.
4
2
.
) in controlled
3
.
6
EN
EN

Publicidad

loading