Publicidad
Idiomas disponibles
Idiomas disponibles
room and close the door. Then, the ozone generation and recovery cycle is triggered, lasting 30 minutes
in total. An intermittent sound and light signal is active throughout the cycle.
• After 30 minutes, the unit returns to normal operation in the preset mode. You can return to the room.
NB: The effectiveness of the Clean Booster treatment depends on the Mode 1 setting. If the adjustment
button
is in the OFF position, the default Clean Booster treatment will be intermediary.
6
IF MODE 2 IS ACTIVE, PLEASE COMPLY WITH THESE SAFETY INSTRUCTIONS.
• Do not breathe the ozone directly above the unit.
• Make sure NO ONE is present in the room during the 30-minute treatment cycle (men, women,
children, and also pets). Plants and fish may remain.
• Close doors, windows, and turn off the ventilation system if possible.
Filter replacement
A light signal indicates when the filter must be changed: the red LED on the cover
specific cases, it may be necessary to replace the filter before the signal appears, notably if you notice
that odour treatment is no longer effective.
• Open the cover to access the filter compartment. To do so, unscrew the two screws
wrench provided.
• Remove the two filter latches
• Remove the filter from the unit.
• Remove the new filter from its protective packaging and put it into place, with the blue pre-filter visible
(there are arrows on the side of the filter to indicate the air direction).
• DO NOT TURN OFF YOUR DEVICE: Reset filter use on the powered purifier by inserting a thin rod,
such as paper clip or pencil tip into the reset button
• Put back in place the filter latches then close the cover using the two screws.
SERVICING
Clean your unit with a soft cloth that is slightly damp to remove dust.
TROUBLESHOOTING HELP
Problem(s) encountered
The unit is no longer
operating
Blue LED on
Blue LED on but weak
Red LED on all the time
Flashing red LED
The red and blue LEDs are
flashing and there is an
intermittent sound signal
(1 beep every 3 sec)
EN
EN
14 - Hygeolis
9
.
Check that the unit is properly plugged in and that the On/Off switch is
pushed in. Check that the unit is not in Sleep mode.
Check that the filter and the filter latches are correctly positioned and that
the cover is properly closed. If an LED is on, see the solutions below.
The unit is operating. If you are not sure, change the speed. If you cannot
hear the suction or cannot feel any air coming out of the unit, check that
the unit is not in Sleep mode. If the unit still does not appear to be running,
contact your dealer.
The unit is in Sleep mode. Air purification is therefore stopped.
To restart the unit, see page 13.
The filter is missing or incorrectly positioned. Insert a filter into the unit or
check that the filter present and the filter latches are correctly positioned.
The filter needs replacing. The unit has been switched off to prevent pollutants
being released back into the air. Follow the instructions on page 14.
Clean Booster treatment is in progress. Evacuate the room and consult the
safety instructions on page 14.
. The red LED then goes out.
7
Solution(s)
flashes. In some
4
using the torx
1
Publicidad
