Publicidad
Idiomas disponibles
Idiomas disponibles
1 - insert the spiral into the hole in the machine
2 - select the appropriate tip and mount it on the spiral
3 - set the machine in the right position (avoid contact with water and dirt) and insert the tip with the spiral
into the pipe as far as possible
4 - leave about 2 to 4 meters of the spiral outside the machine
5 - connect the machine to the power supply
6 - turn on the machine with the knob - the spiral should rotate clockwise
7 - keep about 20-30 cm of the spiral between the machine and the pipe inlet; switch the rotation switch to
the appropriate position and correctly set the control handle, slowly insert the spiral into the pipe; repeat the
steps until the pipe is unblocked
8 - after turning off the machine, remove the spiral, impurities and dry it; NOTE: Avoid inserting the
contaminated spiral into the machine
9 - after finishing work, leave the machine running at idle speed for about 2 minutes; insert a small amount
of oil into the oil holes
CAUTION! Always be prepared to stop the machine immediately!
3.3.
Cleaning and maintenance
a)
Pull the mains plug and let the unit cool down completely before cleaning, adjusting or replacing
accessories and when the unit is not in use.
b)
Pull out the mains plug before each cleaning and when the unit is not in use.
c)
Use only non-corrosive cleaning agents for cleaning the surfaces.
d)
After each cleaning, all parts should be thoroughly dried before the device is reused.
e)
Store the unit in a dry and cool place protected from moisture and direct sunlight.
f)
Do not spray the unit with a stream of water or immerse it in water.
g)
Perform regular inspections of the unit, checking technical fitness and any damages.
h)
Use a soft cloth for cleaning.
i)
Do not clean the unit with acidic substances, medical agents, thinners, fuel, oils or other chemicals. It
may cause damage to the device.
j)
After finishing work, leave the device running at idle speed for about 2 minutes. Put a small amount of
oil into the oil holes - depending on the model of the machine.
k)
All working elements, such as the spiral, outlet nozzles, tubes, should be kept clean. The spiral should
be properly lubricated (oiled).
Publicidad
