Notes On Service And Maintenance; Intended Use - TE Connectivity AWG14 Manual De Instrucciones

PN 9-744010-7 411-18315 Rev. H
2.3

Notes on service and maintenance

Prior to operation the tool must be in a proper and clean condition. Any residues should be removed with
a soft brush or cloth.
The joints should be oiled regularly with light precision mechanics oil and protected against soiling.
Once the hand tool is no longer required it should be stored, dry and clean, in the case provided.
3

Intended use

The SOLARLOK crimp hand tool applies SOLARLOK crimp contacts with a cross section of
2,5 / 4 / 6 mm².
The hand tools and heads are only to be used for the contacts listed in table 1. The contacts may only be
used in combination with SOLARLOK wire approved by TE Connectivity.
Note:
Dimensions on this sheet are in millimetres [mm]. Figures and illustrations are not drawn to scale. The
handling is shown on the example of the crimp hand tool P/N 1-1579004-2.
Application Notes
Cumulative Trauma Disorders can result from a prolonged use of manually powered hand tools.
TE Connectivity hand tools are intended for occasional use and low volume applications. For extended
use or production operations TE Connectivity offers a wide selection of powered application equipment.
Page 14 / 47 ECOC: EGC0 ; LOC: AI