USAG 075 PD Manual De Instrucciones página 14

Replacing the battery (1 battery, 9V, 6F22)
• If the " "con appears on the display, the batteries shall be replaced.
Warning: before opening the instrument to replace the battery
proceed as follows.
• Disconnect the clamp meter from the currente cable being checked.
• Disconnect the leads from any source, turn off the instrument and remove
the leads from the bushings.
• Remove the door of the battery compartment at the back of the instrument.
• Replace the battery with an equivalent one.
• Alwais close the battery compartment before using the instrument.
Accessories
• Couple of leads
• Temperature sensor type K (max 200 ºC).
• Nylon bag for transport.
• Operating instructions.
14