ATH-Heinl Single Lift 12PL Manual De Instrucciones página 67

Content
Main column with hydraulic
unit and control
Crossbeam
Accessories box
2 platforms
2 ramps
Column cover
small parts (screws etc.)
instruction manual with test
book
Note
If anything is missing from the package, please contact our sales department.
2.4 Location
The machine should be kept away from flammable and explosive materials, as well as from sunlight and intense
light. The machine should also be placed in a well-ventilated place.
The machine should be installed on sufficiently solid ground, if necessary according to the minimum
requirements of the specifications in the foundation plan.
When selecting the installation site, the guidelines and instructions of the accident prevention regulations and
the workplace regulations must be observed in addition to the ground conditions.
If the unit is to be installed on a floor slab, its sufficient load-bearing capacity must be checked. In general, it
is recommended that a building expert be consulted for an assessment when installing the machine on floor
ceilings.
The machine is only to be installed and used inside closed rooms. It does not have appropriate safety equipment
(e.g. IP protection, galvanized design) for outdoor use.
Temperature
Sea level
Humidity
® Copyright ATH-Heinl GmbH & Co. KG / All rights reserved / Misprints and technical changes reserved
Length
3.000 mm
Release date: 02.05.2023 / Product manufacturer ATH-Heinl GmbH & Co. KG
Width Height
830 mm 645 mm
5 - 50°C
< 1500m
50% at 40°C - 90% at 20°C
Weight
630 kg
67