GreenWorks HMG405 Manual Del Operador página 8

EN
8.4 INSTALL THE BIT
1. Push forward / reverse switch in the center position to
lock the trigger.
2. Put bit into coupler.
8.5 REMOVE THE BIT
2
1. Pull back the clamp collar and remove the bit.
9 OPERATION
Always wear eye protection.
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
1
1
1
WARNING
WARNING
English
9.1 START THE MACHINE
The machine can not work until the forward / reverse switch
is pushed fully to the left or right. Do not operate the
machine at low speeds for extended periods of time.
1. Pull the trigger to turn the machine ON.
Variable speed
The machine has a variable speed switch that delivers higher
speed with increased trigger pressure and lower speed with
decreased trigger pressure.
9.2 STOP THE MACHINE
1. Release the trigger to turn the machine OFF.
Release the trigger and allow the machine to come to a
complete stop.
9.3 FORWARD / REVERSE SWITCH
The machine has the switch(forward/reverse) above the
switch trigger to change the rotation.
1. When the switch is on the left side of the switch trigger,
the bit direciton is forward (tightening).
2. When the switch is on the right side of the switch trigger,
the bit direction is reversed (loosening).
8
NOTE
WARNING