Trust START-LINE AWST-8800 Manual De Instrucciones página 4

EN
AWST-8800 WIRELESS WALL SWITCH
1. Open wall switch
A Open the wall switch with a screwdriver.
2. Learn code to Trust Smart Home
receiver
To control 1 or several receivers simultaneously,
assign the transmitter code to 1 or more
receivers. Read the receivers manual for the
code learning procedure. Send an ON-signal by
pressing the [ON] button while the learn mode
is active.
3. Set the switch-off delay time
In position [0], the light stays on until you send
an off-signal manually. By setting the switch
to 5s/30s/2m/10m/30m/1h/3h, the transmitter
will automatically send an OFF-signal after the
selected time (5 seconds/... /3 hours). If you press
ON in the meantime, the wall switch will
restart the countdown.
4. Affix the transmitter using screws
A
Use a flathead screwdriver to remove the
button first.
B
Then place the flat screwdriver in the recess of
the frame and lift the screwdriver to unclip the
frame from the back plate.
C Screw the backplate to a location with a flat
surface (make sure the arrow on the back
plate points up). First click the frame back onto
the backplate and then the push button.
4
5. Affix the transmitter using double-
sided tape
A
Apply double-sided tape to the back of the
wireless switch.
B
Stick the wireless wall switch onto a flat
surface, e.g. a wall.
6. Control 1 or multiple Trust Smart Home
receivers
You can assign the AWST-8800 to one receiver
or you can assign the AWST-8800 to multiple
receivers, to control them simultaneously. Read
the receivers manual for the code learning
procedure.
7. Manual operation of a Trust Smart
Home on/off receiver
A
Press ON once to switch the receiver on.
B Press OFF to switch the receiver off.
8. Manual operation of a Trust Smart
Home dimmer receiver
A Press ON once to switch the receiver on.
B
Press ON again to activate the dim-mode.
The light will slowly dim up and down.
C Press ON a third time to select the desired
light intensity.
D Press OFF to switch the receiver off.