Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
SHARPENING THE CHAIN
– Wear personal protection equipment
– Sharpen all the cutters on the same side and then adjust the vise as explained in
the previous sections, and sharpen the cutters on the opposite side
– When grinding is complete, ensure all cutter top plates equal length
A
A=B
Make sure the vise handle (13) has been pulled
to the right and the vise jaws (14) are tight,
and the cutter is blocked (10) properly
26
B
Start the grinder by turning the
switch to position "l"
Sharpen the cutter by lowering the
grinding wheel with handle (E)
410-120
410-120
Once you have sharpened the first cutter,
raise the motor unit with handle (E)
Loosen the vise handle (13)
Advance the chain forward to position
the next cutter to be sharpened, assuring
that the chain stop (10) is seated firmly
against the rear of the cutter
OPERATING INSTRUCTIONS
Clamp chain again with the vise handle (13)
and sharpen the next cutter
27
Publicidad
