Descargar Imprimir esta página

Oregon 410-120 Manual Original De Instrucciones página 16

Ocultar thumbs Ver también para 410-120:

Publicidad

Idiomas disponibles

Idiomas disponibles

STOPPING, MAINTENANCE, DISPOSAL
STOPPING AND SHUTTING DOWN
STOPPING
Turn the machine off by turning the
switch to position "0" and unplug the
power cable from the mains
MAINTENANCE AND CLEANING
WARNING Grinder must be turned off and
the power cable unplugged from the mains
before any maintenance is performed
Inspect the power cord regularly for
damage Remove the plug from the mains
immediately if the cable is damaged or cut
When the grinding wheel reaches a
minimum diameter of approximately
105 mm, replace the grinding wheel
DEMOLITION AND DISPOSAL
The machine is to be demolished by qualified
personnel in compliance with current laws in
force in the country in which it is installed The
symbol (on the rating nameplate) points out
that the product must not be disposed of with
normal household garbage Contact an authorized
shop or your dealer for disposal instructions
Before you scrap the machine, make it
unusable by cutting the power supply cable,
for example, and make the parts safe, which
could cause a source of danger for children
if they should play with the machine
30
410-120
SHUTTING DOWN
Once you have finished using the machine,
disconnect it and clean it thoroughly
Store it in a dry, safe place, protected
against dust and dampness
After 40 hours of use:
– Clean the lamp carefully using a rag or a
cleaning brush Do not use compressed air
– Clean the grinder carefully using a rag
or a cleaning brush Clean the electric
motor and the sliding guides with
caution Do not use compressed air
410-120
WARRANTY AND SERVICE
The warranty validity is that acknowledged in the country of sale Claims
under warranty will only be accepted if they are backed up by the copy of the
purchase document (bill or receipt) The guarantee becomes void if:
– The machine has been tampered with;
– The machine has not been used according to this manual;
– Non-original parts, machines or grinding wheels have been fitted on the
grinder or other parts that are not authorized by the manufacturer;
– The machine has been powered at a voltage or frequency different
from that written in the rating nameplate
THE OREGON® CUSTOMER-SATISFACTION POLICY
LIMITED WARRANTY
OREGON® | Blount, Inc warrants its products to be free from defects in materials and
workmanship for as long as they are owned by the original retail purchaser
If you like our products, please tell your friends If you are not satisfied with our products,
for any reason, please tell us OREGON® wants to provide you with products that perform
to your full satisfaction We welcome you to contact us as shown below
LIABILITY UNDER THIS WARRANTY IS LIMITED TO REPLACEMENT PARTS, AT THE OPTION
OF YOUR OREGON® DISTRIBUTOR AND OREGON® PLEASE CONTACT YOUR OREGON®
DISTRIBUTOR OR US DIRECTLY OREGON® PRODUCTS ARE NOT WARRANTED AGAINST NORMAL
WEAR AND TEAR, USER ABUSE, IMPROPER MAINTENANCE OR IMPROPER REPAIR
REPLACEMENT OF DEFECTIVE PRODUCT IS THE EXCLUSIVE REMEDY UNDER THIS WARRANTY AND
ANY APPLICABLE IMPLIED WARRANTY THE REPLACEMENT WILL BE UNDERTAKEN AS SOON AS
REASONABLY POSSIBLE AFTER RECEIPT OF THE DEFECTIVE PRODUCT TO THE EXTENT PERMITTED
BY LAW, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE
APPLICABLE TO THIS PRODUCT IS LIMITED TO THE DURATION AND SCOPE OF THIS EXPRESS
WARRANTY OREGON® SHALL NOT BE LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES
SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS OR
DO NOT ALLOW THE EXCLUSION OF CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR
EXCLUSION MAY NOT APPLY TO YOU THIS WARRANTY GIVES THE ORIGINAL OWNER SPECIFIC
LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE
If you have questions regarding OREGON® products in the U S A or Canada, our Technical Services
Department welcomes all calls between the hours of 6:30 a m and 4:00 p m (Pacific Time), Monday
through Friday, at 800-223-5168 Alternatively, you can write to: Technical Services Department,
OREGON® | Blount, Inc , P O Box 22127, Portland, Oregon 97269-2127, visit our website at
www oregonproducts com (look for the "Contact Us" link under the "Customer Service" menu),
or email us directly at technicalservices@oregonproducts com
WARRANTY AND SERVICE
31

Publicidad

loading