Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly–Roof
11
HH
1
H o
l e
F r o
n t
J
Place roof on flat surface and lower each support bracket
(J) into channels on under side of roof panel (H). Support
bracket (J) top hole must be on the right side for proper
orientation. Align holes in truss legs to rockets on roof panel.
Attach bracket using ten screws (HH) for each.
Note: Support brackets must be installed in orientation
shown above. Roof will not fit if brackets are installed
backwards.
13
H
L
x7
1
x20
J
x2
H
12
I
Lower S-bracket (I) into position on roof (H). Attach
using ten screws (HH). S-bracket (I) proper orientation is
shown above.
Note: There are no pre-drilled holes on the roof. Use
force when starting to drive self-tapping screws. Once
the screw pierces the plastic, it will drive easier.
Lower roof bracket (L) into position on roof. Secure
bracket with easy bolt (EE). Do Not use torque wrench.
Use easy bolt easy driver (FF) to hand tighten. Easy bolt
head will be flush when fully seated. Do Not over tighten
easy bolts.
EE
x7
14
I
H
1
F r o
n t
HH
x10
Publicidad
