Brother PA-CU-002 Guia De Instalacion

Installation Guide
Cutter Module (PA-CU-002, PA-CU-003)
TD-4420TN/TD-4520TN
NOTE
Only Authorized Brother Dealers should perform accessory replacements.
1. Open the printer's Top Cover and push the print head release button to open the
print head.
2. Remove the lower front panel.
3. Close the print head.
4. Remove the four screws on the media holder and then remove it, as illustrated
below.
5. Push the Cutter Module's cable and ground line through the slot into the main board
compartment.
Installation Guide
Cutter Module (PA-CU-003)
TD-4650TNWB/TD-4750TNWB
NOTE
Only Authorized Brother Dealers should perform accessory replacements.
1. Open the printer's Top Cover and push the print head release button to open the
print head.
2. Remove the lower front panel.
3. Push the Cutter Module's cable and ground line through the slot into the main board
compartment.
D01CNK001
Screws
(5 - continued)
6. Slide the Cutter Module into the lower front panel slot until it locks into place.
7. Connect the cable and ground line to the CON6 and JP2 sockets on the main board.
(The ground line can be connected to any available JP2 socket.)
8. Reattach the media holder using the four screws.
9. To complete the installation, load the media before you turn on the printer.
For more information about loading the media with the Cutter Module installed, see
the User's Guide.
4. Slide the Cutter Module into the lower front panel slot until it locks into place, and
then close the Top Cover.
5. Turn over the printer. Remove the six screws on the bottom cover and then remove
it, as illustrated below.
(To avoid scratching the LCD screen, place the printer on a soft cloth.)
Screws
6. Connect the cable and ground line to the CON6 and JP2 sockets on the main board.
(The ground line can be connected to any available JP2 socket.)
CON6 JP2
7. Reattach the Bottom Cover using the six screws.
8. To complete the installation, load the media before you turn on the printer.
For more information about loading the media with the Cutter Module
installed, see the User's Guide.
JP2
CON6