Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
Intended Use
1.
The Whirl-A-Way is designed to rapidly clean large, flat surfaces
such as concrete floors.
2.
It is not intended to clean rough or uneven surfaces such as stairs.
Uneven surfaces can cause damage.
3.
The pressure washer must be rated to make the Whirl-A-Way
operate properly. For the standard nozzles that come with the
Whirl-A-Way the pressure washer must have the following.
• 1/4" Quick-connect coupler on the end of the spray wand
• 1,500 - 4,000 PSI rating
• 2.0 - 3.0 GPM rating
• Cold water pressure washers only
Pre-Operation Instructions
1.
Remove Whirl-A-Way from packaging. Ensure there is no damage
and that rotary arm freely spins by hand.
2.
Connect Whirl-A-Way to the end of the spray gun wand. The
spray wand will need to have 1/4" quick connect coupler to
attach to the 1/4" quick connect plug on the Whirl-A-Way.
3.
Prepare your pressure washer for start-up as per its start-up pro-
cedure found its manual.
4.
Once water is connected to the pressure washer, squeeze the
trigger of the spray wand to ensure that water flows through the
whirl-a-way.
5.
Level the Whirl-A-Way onto a flat surface.
6.
Start the pressure washer as instructed in its manual.
Operating Instructions
1.
Walk slowly behind the Whirl-A-Way moving it in a rhythmic side-
to-side motion.
2.
If striping or swirling occurs then slow your pace.
3.
If striping or swirling continues then it is likely the nozzles are
clogged or damaged. If they are damage you will see visible
deformation of the nozzle from impact. If there is no damage,
then they need to be cleaned. See the Nozzle Maintenance
section for details.
4.
When done working, always flush with clean water. Detach from
your pressure washer and drain out any water to prevent possible
freezing damage. Store in a manner so not to deform the bristle
skirt.
5
Publicidad
