AROHA CS11 Manual Del Usuario página 8

Activate and deactivate
The device is deactivated by default before leaving the factory. Before the device can be
used normally, the product must be activated. Flip the switch on the backside to the "ON"
position. To store the unit the switch can be set back to the "OFF" position. The unit also
activates automatically if it is attached to its baseplate.
Test your detector
Test the unit to ensure proper operation by pressing the cover. The alarm will sound if the
unit is working well. If there is no sound, refer to the "Trouble shooting" section.
CAUTION:
• DO NOT test your detector using an open flame. This may damage the alarm or ignite
combustible materials and start a structural fire.
• DO NOT stand close to the detector when the alarm is sounding. Exposure at close
range may be harmful to your ears.
• Test this detector once a month.
Alarm
If an alarm signal sounds immediately move to fresh air and do not re-enter the building
until it has been aired out and your alarm returns to its normal condition. Investigate the
source of the alarm and repair the defect. NEVER IGNORE ANY ALARM, while you can
see smoke, carbon monoxide is invisible and can be deadly.
Silence mode
When the detector is going off you can push the test button to pause it for approx. 10
minutes. During this silence mode the red LED will flash once every 8 second. The silence
feature is only to be used when the source of the alarm is known and safe. The detector will
automatically reset after approximately 10 minutes.
CAUTION: Before using the detectors silence mode, identify the source of the alarm