Publicidad
Idiomas disponibles
Idiomas disponibles
2 INSTALLATION
Installation should be performed only by expert
personnel authorised by the manufacturer.
During installation, ensure that the power source
is disconnected from the mains.
2.1 Lifting, transport & unloading
- The equipment is provided with a handle for hand transportation.
Do not underestimate the weight of the equip-
ment: see technical specifications.
Do not move or position the suspended load
above persons or things.
Do not drop or apply undue pressure on the
equipment.
2.2 Positioning of the equipment
Keep to the following rules:
- Provide easy access to the equipment controls and connections.
- Do not position the equipment in very small spaces.
- Do not place the equipment on surfaces with inclination
exceeding 10° from to the horizontal plane.
- Position the equipment in a dry, clean and suitably ventilated place.
- Protect the equipment against pouring rain and sun.
2.3 Connection
The SELCO mobile units are powered exclusively at low voltage.
20
2.4 Installation
Connection for MIG/MAG welding
- Disconnect the power supply from the power source.
- Open the left side cover.
- Connect the signal cable (1) to the appropriate connector.
- Connect the power cable (2) to the appropriate attachment.
- Tighten the cable clamps and close the left side cover.
- Connect the MIG torch to the central adapter (3), ensuring
that the fastening ring is fully tightened.
- Open the right side cover.
- Check that the roller groove is consistent with the diameter of
the wire you wish to use.
- Unscrew the ring nut (4) from the spindle and insert the wire spool.
Insert also the spool pin, insert the spool, reposition the ring
nut (4) and adjust the friction screw (5).
- Release the rolls lever of the wire feeder (6), sliding the end
of the wire into the wire guide bush and, passing it over the
roller, into the torch fitting. Lock the feed support in position,
checking that the wire has entered the roller groove.
- To load the wire onto the torch, press the wire feed push-button.
- Connect the gas hose to the rear gas hose coupling.
- Adjust the gas flow from 5 to 20 l/min.
Publicidad
