Mitsubishi Electric Mr.SLIM PKA-RP HAL Serie Manual De Instrucciones página 5

Remote controller display
*For explanation purposes, all of the items
that appear in the display are shown.
*All items are displayed when the Reset but-
ton is pressed.
Set Temperature buttons
Fan Speed button (Changes fan speed)
Mode button (Changes operation mode)
When using the wireless remote controller, point it towards the receiver on the indoor unit.
If the remote controller is operated within approximately 2 minutes after power is supplied to the
indoor unit, the indoor unit may beep twice as the unit is performing the initial automatic check.
received. Signals can be received up to approximately 7 meters in a direct line from the indoor
lights and strong light can affect the ability of the indoor unit to receive signals.
If the operation lamp near the receiver on the indoor unit is blinking, the unit needs to be in-
spected. Consult your dealer for service.
Handle the remote controller carefully! Do not drop the remote controller or subject it to strong
shocks. In addition, do not get the remote controller wet or leave it in a location with high hu-
midity.
To avoid misplacing the remote controller, install the holder included with the remote controller
on a wall and be sure to always place the remote controller in the holder after use.
Outdoor unit
ON/OFF button
Check button
Test Run button
Ref. Pipes
Indoor-Outdoor
Connection wire
Service Panel
Transmission area
Transmission indicator
Timer indicator
Operation areas
Timer Off button
Timer On button
Hour button
Minute button
Set Time button (Sets the time)
Reset button
1. Remove the top cover, insert 2 AAA batter-
ies, and then install the top cover.
1
Top cover
2. Press the Reset button.
Power
Earth
2
3
Two AAA batteries
Insert the negative (–)
Install the batteries in
the correct directions
(+, –)!
Press the Reset button
with an object that has
a narrow end.
5