BE WHIRL-A-WAY Manual De Usuario página 12

Troubleshooting
Problem
Rotary arm not spin-
ning
Low pressure or slow
spinning
Leaking water from
weep hole
Leaking water from
QC plug
Unit vibrating while
in use
Rotary Head Repair Parts
A repair kit for this Whirl-a-Way's rotary head, is available.
If you encounter problems with the rotary head after the 1 year warranty
has expired, this repair kit (part #85.790.010) allows you to replace the inner
components very quickly.
The rotary head has a snap ring on the bottom holding all the bearings inside.
By removing the snap ring and washer, you can tap off the outer shell with a
hammer while the output shaft is held in a vice. The rotary head repair kit can
then be used to replace the worn items inside the rotary head shell.
PART #
NO#
85.790.010
1
85.790.001
2
85.790.002
3
85.790.011
4
12
TROUBLESHOOTING / PARTS LIST
Cause
• 1 or more plugged nozzles
• Nozzles not aligned with arm
• Damaged nozzle or rotary arm
• Inline filter in the plug is
clogged
• Damaged or worn seals
• Damaged or missing o-ring in coupler
• One or more plugged nozzles
• Uneven nozzle wear
• Damaged nozzle or rotary arm
• Miss matched nozzles
DESCRIPTION
Rotary Head Rebuild Kit
Inlet Valve
Inlet Valve Viton O-Ring
Outlet Shaft
Solution
• Clean or replace nozzles
• Realign nozzles
• Replace damaged part(s)
• Clean or replace
• Replace rotary head
• Replace o-ring
• Clean nozzles
• Replace damaged part(s)
• Replace nozzles