Tank Emptying - Clarke Vantage 14 Instrucciones De Uso

TANK EMPTYING

An automatic loat shut-off system (25) turns off the vacuum system when the recovery tank is full.
The vacuum system shutdown is signalled by an increase in the vacuum system motor noise, moreover the loor is not dried.
CAUTION!
If the vacuum system turns off accidentally (for example, when the loat is activated because of a sudden
machine movement), to resume the operation: turn off the machine with the function selection knob (31) turned
to "0", check that the loat inside the grid (25) has gone down to the water level. Then turn on the vacuum
system by pressing the function selection knob (31).
When the recovery tank (23) is full, empty it as shown.
Solution and recovery tank emptying
1. Check that the function selection knob (31) is turned to "0".
2. Drive the machine to the appointed disposal area.
3. Remove the transparent cover (24).
4. Grasp the handle (A, Fig. 3) and lift the tank assembly (B).
5. Empty the recovery tank (C). Then, rinse the tank with clean water.
6. Open the plug (D) and drain the solution tank. Then, rinse the tank with clean water.
7. Reinstall the tank assembly (22) on the machine frame and the transparent cover (23).
B
INSTRUCTIONS FOR USE
Figure 3
9099878000 - VANTAGE 14
C
A
ENGLISH
D
P100409
13