Publicidad
Idiomas disponibles
Idiomas disponibles
Step 5. Press the release button on
the zip tie to lift the pump out of
the basket.
Step 6. To clean the pump, remove
the impeller cover to expose
the impeller assembly. Remove
the impeller assembly by gently
pulling on the impeller blades.
The impeller is held in place by a
magnet.
Use a soft cloth or brush and warm
water to clean the impeller and the
inside of the impeller housing.
Step 7. Remove the nozzle and
clean with warm water.
Step 8. Remove the light ring by
turning counterclockwise and clean
with warm water.
Step 9. Reassemble all parts
making sure to fasten all interior
electrical cords safely. Place
the fountain into the water, and
connect the fountain into a
properly grounded electrical outlet.
IF THE LED LIGHTS FAIL TO OPERATE:
• Check to make sure the power cord is plugged in and the light
is getting power and the unit is getting power.
• Check to make sure the Dusk-to-Dawn Sensor is covered if you
would like the lights to operate during the day.
IF THE PUMP FAILS TO OPERATE:
• Check to make sure the power cord is plugged in, the pump is
getting power and the pump is fully submerged.
• Remove the impeller cover to expose the impeller. Turn the
impeller to ensure that it is not broken or jammed.
IF THE PERFORMANCE OF THE PUMP IS NOT SATISFACTORY
OR THE PUMP DOES NOT FLOW EVENLY:
• Check to make sure the pump is completely submerged in water.
• Check to make sure the impeller and the pump housing are
clear of debris.
• Check to make sure the pumpshield
• Check the pump outlet, nozzle and any tubing for kinks or
obstructions.
For product maintenance videos visit totalpond.com
8
TROUBLESHOOTING
Visit WWW.TOTALPOND.COM for information and tips.
5
Zip tie release button
6
7
8
is clean.
®
Publicidad
