Publicidad
Idiomas disponibles
Idiomas disponibles
3
• The pulsator rotates for
8 seconds to detect the
laundry load.
• Then the WATER LEVEL
and the amount of
Detergent to be used
will be shown and
water will be supplied.
4
4
4
4
Close the lid
5
• Water will be
• When the wash
supplied for 2
program ends, the
minutes after the
buzzer will ring
start of the wash to
for 10 seconds
supplement the
before the Power
water the laundry
goes off
has absorbed.
automatically.
6
6
6
6
Finish
• If water is already in the tub, or putting wet
6
laundry into the tub before starting will
increase the WATER LEVEL.
• With lightweight bulky loads, WATER LEVEL
can be set low.
• Changes to Water Temperature (HOT/COLD)
and wash level are possible during operation.
(refer to page 14)
• When setting the WATER LEVEL manually,
7
do not set to Medium to prevent damage to
laundry.
• Washing with HOT water may damage the
laundry (Water is set to cold automatically).
Ensure that the load is under 2kg.
• In order to avoid damage to laundry,
the spin cycle may appear slow.
This also avoids wrinkles and clothing may
still contain some water. This is normal.
• When static pressure of water is more than
7
2kg/cm
within 19min.
7
7
Caution & Note
, the QUICK WASH course will be
2
17
Publicidad
