Publicidad
Idiomas disponibles
Idiomas disponibles
2
1
012625
Bit angle
(when chipping, scaling or demolishing)
012632
The bit can be secured at the desired angle. To change
the bit angle, depress the lock button and rotate the
action mode changing knob to the O symbol. Turn the bit
to the desired angle.
Depress the lock button and rotate the action mode
changing knob to the
bit is securely held in place by turning it slightly.
012633
Depth gauge
1
3
2
012626
The depth gauge is convenient for drilling holes of
uniform depth. Loosen the side grip and insert the depth
gauge into the hole in the side grip. Adjust the depth
gauge to the desired depth and tighten the side grip.
1. Bit
2. Chuck cover
1. Action mode
changing knob
2. O symbol
2
1
symbol. Then make sure that the
1. Hole
2. Depth gauge
3. Loosen
4. Tighten
4
NOTE:
The depth gauge cannot be used at the position
•
where the depth gauge strikes against the gear
housing.
Dust cup
012636
Use the dust cup to prevent dust from falling over the tool
and on yourself when performing overhead drilling
operations. Attach the dust cup to the bit as shown in the
figure. The size of bits which the dust cup can be
attached to is as follows.
Dust cup 5
Dust cup 9
006386
OPERATION
Hammer drilling operation
012634
Set the action mode changing knob to the
Position the bit at the desired location for the hole, then
pull the switch trigger.
Do not force the tool. Light pressure gives best results.
Keep the tool in position and prevent it from slipping
away from the hole.
Do not apply more pressure when the hole becomes
clogged with chips or particles. Instead, run the tool at an
idle, then remove the bit partially from the hole. By
repeating this several times, the hole will be cleaned out
and normal drilling may be resumed.
CAUTION:
There is a tremendous and sudden twisting force
•
exerted on the tool/bit at the time of hole
break-through, when the hole becomes clogged
with chips and particles, or when striking reinforcing
8
1. Dust cup
1
Bit diameter
6 mm (1/4") - 14.5 mm (9/16")
12 mm (15/32") - 16 mm (5/8")
symbol.
Publicidad
