Descargar Imprimir esta página

wad Zefir CW003 Manual Del Usuario página 5

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 18
Cut with 7 measures
You can use the machine to cut without a comb or you can use one of the 6 combs with sizes 0.5, 1.5, 3, 6, 9 and 12
mm. To adjust the hair size, just select the right comb.
0,5 mm
1,5 mm
Use of the cutting machine
Before using the machine, put a few drops of
1
lubricating oil on the blades.
8
3 mm
6 mm
9 mm
Press the power button to start the blades.
2
3
Pass the machine over the desired cutting area.
Press the off button when the work is
4
finished.
Adjustment of blades and combs
To adjust the blade:
· To adjust the blade,
move the lever from front
to back.
12 mm
Removal and installation of the blades
You will see in the drawing that the
lower blade holes are larger than
the shanks of the blade screws.
Loosen the screws, align the lower
blade with the upper blade and
tighten the screws firmly.
For mounting the combs:
· Align the edge of the
comb with the edge
of the blade and push
forward slightly to
assemble.
To dismantle the combs:
· Simply pull the
comb tightly.
(1) The end of the upper blade
(3) The right end tooth of the
teeth should be 0.5 to 1 mm behind
upper blade must touch the large
the lower blade. This is important
tooth of the lower blade.
so that the razor does not cut
too close or allow the moving blade
to touch the skin.
(2) The left end tooth of the upper
blade must cover or be to the
left of the first small tooth of the
lower blade.
9

Publicidad

loading