Tripp-Lite AGPD7897 Serie Manual Del Propietário página 4

Installation
Connecting the PDU
2-1
(Models with IEC power inlet or
3-pole IEC 309 plug only) Select
models have a detachable power cord.
Attach the included power cord to the
PDU by inserting the IEC connector
of the power cord into the IEC power
inlet B located near the end of the
PDU. Use the included bracket
secure the power cord connection.
Note: Optionally, a user-supplied power cord
can be attached to the PDU by connecting it
to the IEC inlet. Do not attempt to attach a
user-supplied power cord unless it is certified
to be compatible with the input power source
that will be used by the PDU.
2-2
(Optional - models with input plug
adapter only) Select models include an
input plug adapter that converts the
twist-lock input plug to a straight-blade
input plug. Attach the input plug adapter
A to the input plug
plug the PDU into a compatible straight-
blade outlet.
2-3
Connect the input plug to a compatible
AC power outlet. If the PDU does not
have a circuit breaker, it should be
provided with a branch-rated over-
current protection device that matches
the rated amperage of the PDU.
Note: The AC power source should not share
a circuit with a heavy electrical load.
2-4
(Option 1 - select models only) If you
attached the cord retention bracket(s),
tie each equipment power cord to the
retention bracket. Attach each cord to
the retention shelf by looping the cord
and securing it with one of the included
cable ties . Make sure that each cord
A
can be unplugged from the PDU without
removing the cable tie.
(Option 2) Use the included C14 and
C20 plug-lock inserts to secure plugs to
receptacles. Attach the insert onto the
plug, making sure that the pull tabs
remain outside the plug and that the fit
is secure. To unplug equipment properly,
use the pull tabs to remove the plug
and insert from the receptacle.
18-12-186-933667.indb 4
A
C
to
B if you wish to
B
4
C
A
B
2-1
B
2-2
2-3
B
2-4
A
A
3/6/2019 5:40:24 PM